Results

    "Dry-powder duster. - canvas harness is fitted over the shoulder and chest; at one end of the duster is a ""rest"" to rest against the hip - on the right of the metal duster is a wooden handle that t

    "Speaker. - black textured plastic horn extends from black painted metal oval base with lip at bottom; 3 holes and 3 metal dials near base of horn - manufactuter's plate affixed to base reads: ""PATE

    Chair with a built in desk top. Wooden slat back, stained wood; right arm of chair has a large flat area for writing (desk area), does not flip; wooden bars across the bottom (underneath seat) to set

    Wooden collar back or bar room Windsor arm chair with curved shaped back rest terminating in slightly scrolled arms, supported by six turned spindles fitted into a solid shaped plank seat, the whole

    Classic spindle, "Jenny Lind" style bed, dark stained wood. Three quarter size walnut headboard (H- 121.92cm) and baseboard (H- 71.12); pine side rails. Each end should have 8 spindles (one missing f

    Wicker plant stand on 4 turned wooden legs, painted dark brown. Legs are attached to an "X" of wood and then attached to underside of pot. 5 square head screws on inside of pot to attach base. Very s

    Wicker plant stand with 4 wooden legs, painted dark brown. Legs are attached directly to bottom of pot, brace near bottom of legs. Twigs are woven decoratively around legs at base of pot and at brace

    Wicker plant stand with 4 wooden legs, painted dark brown. Legs are attached directly to bottom of pot, brace near bottom of legs. Twigs are woven decoratively around legs at base of pot and at brace

    - this very early chair is directly related to the 17th century "Carver" chairs that were made in New England. - wooden banister back arm chair with integral turned back posts forming rear legs and s

    Wooden slat back side chair with slightly tapered back posts extending to also form the rear legs with two shaped back supports above a shaped seat form. The front legs are simple square wood with th

    Wooden slat back side chair with sausage-turned back posts ending in ball finials with three shaped back splats. The front posts are also turned with a decorative turning below the seat and a mushroo

    Wooden Windsor side chair with scrolled crest rail supported by two turned posts flanking a vase shaped centre splat all mortised into a solid plant seat supported by four plain turned legs with box

    Six circular metal disks lined up from top to bottom on a centre tube, disks are very flat cone shaped with the widest part up and level. Base, tube, and circular disks are hollow. The base has a spo

    Unfinished wood flax break, pegged construction. 3 bars supported horizontally on 2 T-shaped legs; long wooden double bladed knife sits on top of bars and is hinged at one end; blunt blades on unders

    Infant's cradle; unfinished tulipwood (yellow poplar). Single board bottom on two elliptical rockers; solid slightly arched head board and smaller footboard; sides straight for 2/3 of the length risi

    Walnut handmade cradle, finished, likely dates from 1840's. Headboard height straight across from sides. Footboard is higher than both sides and headboard, the top has cut corners. Side boards are ta

    Beam scale. Long, graduated arm which has a weight permanently attached with a ring that allows it to slide along the gradations. Three large hooks and one smaller hook attached to one end of the arm

    Auger, long metal rod, handle is missing. The top looks hand forged but the bottom part looks machined. Bottom point has a feed screw. The twist at the bottom tapers as it turns into the shank. Shank

    Post hole auger. Shank is metal. Shaped wooden handle attached via a piece shaped like a plumbing tee attached to the shank. The opposite end of the shank has a "Y" shaped attachment which holds spad

    Tobacco needle. Copper alloy welded into a rectangle, open at one end, comes to sharp point at other end; handmade. Used to attach tobacco plant onto tobacco slat or picket (see 992.13.3 & .4) Aiguil